![Mohawk Mohawk](https://i.pinimg.com/236x/a0/3f/4c/a03f4c661ff1ec581178f2f6552fe416.jpg)
Jul 20, 2018. Newer canoes and kayaks often have a sticker placed next to the HIN that gives the vessel’s serial number. Relaxing sounds 2 0 – pleasant nature sounds. The HIN: Is a 12-digit serial number that uniquely identifies a vessel. Is usually stamped or embossed on the starboard side at the stern of the hull. However, the location may vary.
![Numbers Numbers](https://www.wcha.org/sites/default/files/OTC-05-65.jpg)
Transporting Sawyer
The robot must be transported using its original packaging form.
When setting up Sawyer for the first time, save the packaging materials in a dry place. The original materials are the best way to pack and transport it if necessary later on. It is specially designed to support the robot such that it will not damage or leave permanent creases in the pads.
Once the robot is in its shipping pose, found in the Head Screen Menu, and powered down disconnect Sawyer’s cables and dismount it from its pedestal. Pack the robot as shown in the photo below. Note that the robot screen has a fitted section it slides into.
Canoe Serial Number Lookup
Similarly, pack the controller in its original packaging. Handle the cables and e-stop with care. Avoid any hard contact with the cable-connection locations. For any cable shipment wrap the cable connectors in bubble wrap or similar protective material to avoid damage.
Fonts used in manga. The pedestal can be transported in its assembled state or in its original packaging.
Important: A calibration should be completed after any transportation of the robot
Important: Do not transport Sawyer on its pedestal.
You now have the finest production canoe available. A few simple steps will protect your investment for years of enjoyable paddling.
Mohawk Canoe Serial Numbers
- When loading or unloading your canoe always place it parallel to shore in ankle deep water so you can avoid damage while loading it. Never load or enter a canoe on dry land – make sure the canoe is floating.
- Don’t drag your canoe over sandbars, gravel beds, dead falls, beaver dams or shallow riffles. Taking a little extra time to lift over obstacles prevents abrasion and scratching of the hull.
- After paddling, clean your canoe with mild soapy water and a freshwater rinse to prevent scum build up. Scum should be removed – it increases friction.
- Protect the hull with frequent applications of 303 Protectant, which slows UV damage and keeps the hull clean. 303 allows scum, road grime and dead bugs to be wiped off easily. Follow instructions on the packaging, and apply whenever water no longer beads on the hull. Do not wax your canoe – wax increases friction.
- If the resin or gel coat has been abraded away and you can touch substantial cloth (aramid, carbon fiber or innegra) you should reseal the cloth. Use either gel coat or resin to reseal. You may use gel coat on a non-gel coated canoe.
- Annual Inspection: We recommend you conduct a complete inspection of your Northstar canoe once yearly. Inspect gunwales, yoke, thwarts, seats, drops and decks for loose hardware. Use a Philips screwdriver and 3/8” wrench to tighten hardware (hint, turn the wrench and keep the screwdriver stationary and you’ll be less likely to strip the bolt head).